Tag: tile adhesive formula,how to make tile adhesive,cellulose ether for tile adhesive,Dosage of tile adhesives
1. Tile adhesive formula
1). Power-solid tile adhesive (applicable to tile and stone pasting on the concrete base surface), proportioning ratio: 42.5R cement 30Kg, 0.3mm sand 65kg, cellulose ether for tile adhesives 1kg, water 23kg.
2).strong type tile adhesive (suitable for exterior wall renovation, superior waterproof function, special board paste), proportioning ratio: 42.5R cement 30kg, 0.3mm sand 65kg, cellulose ether for tile adhesives 2kg, water 23kg.
2. How to use tile adhesive?
1) Mix the tile glue and water according to 3.3:1 (25KG/bag, about 7.5 kg of water) with an electric mixer to form a uniform, powder-free paste, wait for the glue to stand for ten minutes and then stir again to increase strength. The construction wall should be moist (wet outside and dry inside), and maintain a certain level of flatness. The uneven or extremely rough parts should be leveled with cement mortar and other materials; the base layer must be cleaned of floating dust, oil stains, and wax to avoid affecting the adhesion; After the tiles are pasted, they can be moved and corrected within 5 to 15 minutes.
2) Spread the glue on the working surface with a toothed scraper to make it evenly distributed, about 1 square meters each time, and then knead the tiles. After the tiles are pasted, they can be moved and corrected within 5 to 15 minutes.
3) If you paste tiles or stones with a deep groove on the back, in addition to the work surface, you should also apply grout to the back of the tiles or the back of the stone.
4.)Tile glue can be used to directly paste tiles on old tile surfaces or old mosaic surfaces.
The binder after evenly mixing should be used up within 5-6 hours (when the temperature is about 20 degrees)
3. Dosage of tile adhesives
The coverage area varies according to the specific conditions of the project
1) Use a 3х3mm toothed scraper about 1.7 kg/m²:
2 ) Use 6х6mm tooth scraper about 3.0 kg/m2:
3.) Approximately 4.5 kg/m2 with a 10х10mm toothed scraper.
Note: Wall tiles use 3х3mm or 6х6mm toothed scrapers: floor tiles use 6х6mm or 10х10mm toothed scrapers.
There are many types of tile adhesives on the market, which can be divided into many categories according to their quality and application areas. The most common ones are strong-type tile adhesives and strong-type tile adhesives, which are suitable for concrete base and exterior wall renovations. Use, so the proportion of materials will be different, the targeted users and the guaranteed effects are also different. In addition, the above also further gives the use of tile glue for users’ reference, and friends who are interested can learn.